Use Power Tools To Cut Your Chain Maille Jewelry Jump Rings
View PDF | Print View
by: Guest
Total views: 34
Word Count: 242
Many rings will be out of shape and will not close correctly.
Two of these cutters are the Jump Ring Standard Cutter and the Koil Kutter.
The coil holder has four grooves and is designed to hold jump ring coils of different diameters.
It must be equipped with a No.
A Dremel flex shaft is not powerful enough to operate this system.
A Dremel or Proxxon hand piece is required to run the Koil Kutter.
Wire diameters from 30 gauge down to 12 gauge can be cut by these saws.
These can usually be obtained from the cutter suppliers.
Insert wooden dowels inside the coil to prevent the coil collapsing during cutting.
You may need to use a few skewers in each coil.
Place coil in coil holder, gently tighten slotted plate and place saw blade in slot, run tool at high speed and quickly move the guide along the coil holder until the cut is finished.
Turn off power and remove blade from slot, never try to place blade in slot nor remove while the motor is running.
The rings should be neatly cut with very few burrs.
This will not only polish the rings but remove many of the burrs.
Apart from speed and ease of use, the major advantage of these cutters is the production of quality rings that will all close neatly and retain their shape.
About the Author
Two Wrench Holders / Tools Keeps - makes easy to handle, carry, keep together and store. Description These stainless steel wrench carriers are designed to hold and arrange box end wrenches and other tools are possible (screw drivers as seen on picture). The 6 inch carrier will hold a small set of box end wrenches, ¼” to ¾” and the 8 inch carrier will hold a larger set from ¼” to 1 ¼”. They are made out of 3/16” round stainless steel rod for durability and strength. They are strong enough to keep tools organized wherever stored. They are easy to unlatch and will stay locked because of the spring action on the fasteners. They uses are only limited to one’s imagination. These product are made in a uniform manner with a CNC machine and made out of high tensile stainless steel so they will not bend or rust or break. Directions Squeeze bottom bar until it is unhooked from clasp. Slide tools on bottom bar and squeeze again until it locks into clasp to keep tools from sliding off. Reasons to Get Help organize your tools, make locating your tools easy, convenience of handling many tools, makes great gifts. They don't break and get ruined like the plastic and rusty metal wrench holders. They work for more than just wrenches. Used by mechanics, farmers, handy-men and wives! Invented and made in the United States of America!
Rating: Not yet rated
Comments
No comments posted.Add Comment
You do not have permission to comment. If you log in, you may be able to comment.